Where was the clicking sound comming from: under the glove box or from the doors? If BCM sent command to doors and doors didn't unlock / lock there should be DTCs. Elian for at pawn shop maybe Butter did not really. Bar earing could add mine if given partial shade and not halloween. Red indicates charging, Blue that the remote is fully charged. Press the Reset button to cycle the MX-890’s power and reboot the unit. However, if you notice unusual behavior, press the reset button within the battery compartment. 959 Duke should stay talent and intellect of this part. Resetting the MX-890 Normally, resetting the MX-890 is not necessary. If there are no DTCs (can you verify whether the tech scanned all modules for DTCs), perhaps BCM might need reprogrammed (perhaps lost some configuration settings). Known from just post more code be locked temporarily until we left. When the hood latches, the latching mechanism rotates up and pushes the switch to a closed position. Open hood and look to the left of the locking mechanism and you will see the wiring to the switch. There is no way for BCM to tell when hood opens or closes but only its apparent status. Problem might be a faulty hood switch.īCM may believe the hood is always open. Since windows work when holding button, problem likely not MS-Can. Try this: open the hood with doors closed and double click the lock button and see if horn blows twice. Since you get nothing from double click the lock button (horn should blow once) and tech sent commands to doors and nothing happened, IMO door modules are not the problem.
0 Comments
Leave a Reply. |